2 X Internal SATA ConnectionsSerial ATA (or SATA) has been designed as a replacement for the existing 40 way IDE cable,the SATA connector and...... more
2 X Internal SATA Connections
Serial ATA (or SATA) has been designed as a replacement for the existing 40 way IDE cable,the SATA connector and cable are smaller (which improves air circulation), with a reducedoperating voltage and pin amount (7 as opposed to 40), the current data transfer rate is
ATA-150 (1.5Gbps).Each connected SATA device or conversion needs it's own cable, this removes the old master/slave set-up and allows for improved data transmission and access speed.The SATA
PCI Cards are compliant with
Serial ATA 1.0 specifications to upgrade your desktopcomputer to allow Dual
Serial ATA RAID Channels and one Parallel
ATA (IDE) Host controller tosupport up to two devices.The
PCI Cards provide two fully compliant
Serial ATA ports to accessStriping (RAID 0) and Mirroring (RAID 1) are supported to improve data performance and provide dataredundancy.Specification:
Serial ATA - 1.5 Gbps (150 MB/s)? Compliant with
Serial ATA 1.0 Specification? Supports 48-bit LBA (Large Disk), hard drives larger than 137 GB? Supports spread spectrum clocking to reduce EMI? Registers as compatible with Parallel
ATA? Single, digital PLL architecture with 1 PLL for both channels
Serial ATA Interface:Supports SATA 1.0 (High Speed Serialised AT Attachment, Revision 1.0),1.5 Gb/s data rate? Completely software transparent with Parallel
ATA? Supports Host adaptor register Interface (SCR, Status and Control Registers)? Supports 48-bit LBA (Large Disk), hard drives larger than 137 GBParallel
ATA Interface:Supports Ultra DMA Mode transfers up to Mode 6 Timing (133 Mbytes/sec)? Supports 48-bit LBA (Large Disk), hard drives larger than 137 GB? Supports PIO Modes up to Mode 4 Timings, and Multiword DMA Mode 0,1,2with Independent Timing of up to 2 drives? Supports Tri-State IDE Signals
PCI Bus:32-bit, 33/66 MHz?
PCI 2.2 compliant
... less
| 
